Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3845 losing wink statements on reboot

3845 is running code 12.3.14T(5) and when it reboots it loses its wink statements.

2 REPLIES
New Member

Re: 3845 losing wink statements on reboot

This could be issue with the configuration register settings. Refer to the document on losing configurations after rebooting the device.

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml

Re: 3845 losing wink statements on reboot

Do a sh ver and check for the configuration register value.

Make sure it is set to 0x2102. If not you can configure the same using the command

(config)#config-register 0x2102

HTH

Narayan

132
Views
0
Helpful
2
Replies