Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3850 doesn't boot automatically, even after boot system switch all flash:packages.conf in the configuration.

3850 doesn't boot automatically, even after boot system switch all flash:packages.conf in the configuration.

After upgrading to the latest code.

 

The system is not configured to boot automatically.  The

following command will finish loading the operating system

software:
 
    boot
 
 

switch: boot

Even with boot system switch all flash:packages.conf in the configuration and save

!
boot-start-marker
boot system switch all flash:packages.conf
boot-end-marker
 

 

All input are welcomed and appreciated.

Thanks

 

1 REPLY
Cisco Employee

The reason that your switch

The reason that your switch is not booting automatically, even though you have the boot statement configured, is most likely your config-register.

Check the output of the 'show version' command, and at the very bottom you should see something like this:

Configuration register is 0x102

If your value is something other than 0x102 change it, from configuration mode, using the command 'config-register 0x102'

1011
Views
0
Helpful
1
Replies
CreatePlease login to create content