Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3850 Lanbase service-policy input

I could not apply service-policy input on an interface of 3850 lanbase but can apply service-policy output on an interface. Have no error but no show on configuration ? Software  version 03.02.02.SE. Is this the way it should be, no service-policy input ?

Thanks for any input

With AutoQos then it appear

interface GigabitEthernet1/0/19

description Connection to hq-3945-r g0/0

switchport access vlan 301

shutdown

trust device cisco-phone

auto qos voip cisco-phone

spanning-tree portfast

service-policy input AutoQos-4.0-CiscoPhone-Input-Policy

service-policy output AutoQos-4.0-Output-Policy

With another policy, it won't allow on input

Found it, I use the policy-map as Input-Policy, change it to something else as KH-Input-Policy and it works.

347
Views
0
Helpful
0
Replies
CreatePlease to create content