Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3925 pim ios 15

hi - i have enabled pim on a 3925 router and it creates a tunnel interface.

this appears to route traffic to the rp over the tunnel interface

if i enable pim on its neighbour router i lose connectivity to the 3925

so basically i have 2 directly connected routers - a 3925 and a 3845

when i apply the following command to the 3845 i lose connectivity to the 3925

ip pim rp-address 192.168.1.1 1
ip pim spt-threshold infinity group-list 1

can anyone help ?

thanks

-paul

  • LAN Switching and Routing
2 REPLIES
VIP Super Bronze

Re: 3925 pim ios 15

Hi Paul,

When you say you loose connectivity, do you mean when you do a "sh ip pim nei" there is no neighbor?

Reza

New Member

Re: 3925 pim ios 15

Hi all,

I have a 2911 with IOS 15.0. It looks like you affirm: it creates a tunnel for every rp-mapping address using as the destination address for every tunnel. But, in my case, don´t lose connectivity. Of course, the statistics of these tunnels have 0 packets in & out.

I would appreciate if someone can tell me if this behaviour can be override. We have automatic tools that take statistics form interfaces and these tunnels make some noise.

Thks.

437
Views
0
Helpful
2
Replies
This widget could not be displayed.