Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4006 Catalyst switch

Question are you allowed to have 2 Ws-x4232-l3 blades in the same 4006 chassie?

Are you allow to install 4507 blade into 4006 chassie? Thanks Stan

2 REPLIES

Re: 4006 Catalyst switch

Hi Thompson

You can make use of the configurator tool which could help you out to find whether you chasis can support the same..

http://www.cisco.com/en/US/customer/ordering/ordering_dynamic_configuration_tool_launch.html

regds

Cisco Employee

Re: 4006 Catalyst switch

Stan,

Why do you want to use 2 WS-X4232-L3 in the same chassis. There is no HA/redundancy mechanism for the 4232's in the same chassis. The chassis should recognise the module though.

4507 blade ???? Are you talking about 4506 blade. If yes then you can use it in 4006 chassis. There is no 4507 blade for 4006 chassis.

HTH,

-amit singh

119
Views
0
Helpful
2
Replies
CreatePlease to create content