Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4006 - Sytem conversion CatOS to IOS

Hello,

I need to upgrade a Catalyst 4006 from CatOS to IOS.

I have some doubt.

Is it possible? Wich are the rquirements? Wich is the procedure? Any issues?

Thanks in advance

Enrico

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: 4006 - Sytem conversion CatOS to IOS

Hi Enrico,

You cannot convert from CATOS to IOS on Cat4006.

SUP 1 & Sup 2 on Cat4000 switch only supports CATOS and NOT IOS.

HTH

Ankur

*PLs rate all helpfull post

Re: 4006 - Sytem conversion CatOS to IOS

Hi,

The Catalyst 4500/4000 Series Supervisor II-Plus, III, IV and V runs Cisco IOS? software only, and does not run Catalyst OS software. While Supervisor 1 and 2 runs only CatOS and can't be converted.

HTH, please rate if it does help,

Mohammed Mahmoud.

2 REPLIES
Cisco Employee

Re: 4006 - Sytem conversion CatOS to IOS

Hi Enrico,

You cannot convert from CATOS to IOS on Cat4006.

SUP 1 & Sup 2 on Cat4000 switch only supports CATOS and NOT IOS.

HTH

Ankur

*PLs rate all helpfull post

Re: 4006 - Sytem conversion CatOS to IOS

Hi,

The Catalyst 4500/4000 Series Supervisor II-Plus, III, IV and V runs Cisco IOS? software only, and does not run Catalyst OS software. While Supervisor 1 and 2 runs only CatOS and can't be converted.

HTH, please rate if it does help,

Mohammed Mahmoud.

404
Views
0
Helpful
2
Replies