4096/8192

[alsayed]

Hello!

Network Design and Config

*************************

part of the Project Like This:SW1(VLAN100) connected to DS1

SwitchB(Vlan200)Connected to DS2;SW1 HAS Stack Link to SW2.DS1 Has L2 Link to DS2

i will setup 2 DSs and 20 vlans and Run HSRP Between it because the 2 6509 sup 1 doesn't support GLBP so plz examine my Config:

DS1

****

STP vlan 100 priority 4096

STP vlan 200 priority 8192

DS2

***

STP vlan 200 priority 4096

STP vlan 100 priority 8192

Now for HSRP

DS1

***

int vlan 100

ip address 100.x.100.3/24

standby 20 ip 100.200.100.1

standby 20 priority 110

standby 20 preempt

int vlan 200

ip address 100.x.200.3/24

standby 21ip 100.200.200.1

DS2

***

int vlan 200

ip address 100.x.200.3/24

standby 21ip 100.200.200.1

standby 21 priority 110

standby 21 preempt

int vlan 100

ip address 100.x.100.2/24

standby 20 ip 100.200.100.1

Now:what is ur Greatfull Comments to this Design/config

10xs

Ali

10xs

[Edison Ortiz]

Very straightforward and I see no problems. Good luck !

[alsayed]

Hello Experts!

Ok,let Say we want to move to GLBP Does this Config Works or must config on the DSs stp side Like this:

DS1

***

Root bridge primary

DS2

***

Root bridge Secondary

than the GLBP Load Balence across all vlans

any great Coments

Ali

[Edison Ortiz]

Leave the STP setup as before, since it's layer 2 share. GLBP will load balance at L3.

[alsayed]

Hello Again!

what if EACH Switch has 2 direct connection to each Distribution(DS1 & DS2).what would be the config of the STP? Shall i keep it the Same?

10xs