Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4500 module compatibility

I have a 4506 (CatOS, WS-X4013 Sup.).

8.4(10)GLX SW version

This chassis currently has 2 of the following copper blades as well...

WS-X4448-GB-RJ45 (Qty. - 2)

I need to add a blade for additional copper ports...10/100 is fine for this situation..

Yes, I know this is an EOS switch/sup/etc...However, I have some spare blades

that are

WS-X4548-GB-RJ45V

Will these blades work in this switch is my question...If not, I guess we are going buy

some "used" 4448....

I have scoured the Cisco website for a 4500 blade compatibility w/o any luck....

Any help would be appreciated...

Thanks

2 REPLIES
Cisco Employee

4500 module compatibility

Wow... the sup II was announced EoL in 2004!!! Niece piece of antiquary you own 

I tried to check in our db to see the supported hw for that engine but unfortunately all pages have been removed and/or archived and I could not find anything.

You just need to plug that LC and see if it is recognized.

regards,

Riccardo

Purple

Re: 4500 module compatibility

Yes those will work ... Check release notes for catos 8.X  . Riccardo dont laugh we still have about 80 Cat4006 chassis running  even though they are end of life. :-)

246
Views
0
Helpful
2
Replies
CreatePlease to create content