Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

4500 Switch - Unsupported Module

I am getting an ' unsupported module' message on 4503 switch for a WS-X4648-RJ45V-E module. Slot 1 has supervisoe V module installed (WS-X4516). The IOS is 12.2(50)SG. Is the module supported in this configuration.

5 REPLIES

Re: 4500 Switch - Unsupported Module

What power supplies are you using?

Re: 4500 Switch - Unsupported Module

I believe you are going to need a sup6-E/E chassis for that particular module to be supported. You are using a supV and I believe the "E" modules must be used with the sup6.

http://www.cisco.com/en/US/prod/collateral/modules/ps2710/ps5494/product_data_sheet0900aecd802109ea_ps4324_Products_Data_Sheet.html')">http://www.cisco.com/en/US/prod/collateral/modules/ps2710/ps5494/product_data_sheet0900aecd802109ea_ps4324_Products_Data_Sheet.html

HTH,

Mark

Hall of Fame Super Bronze

Re: 4500 Switch - Unsupported Module

You need a 4503-E Switch.

If you just purchased this module, return it and get WS-X4548-GB-RJ45V

HTH,

__

Edison.

Community Member

Re: 4500 Switch - Unsupported Module

The chassis is a 4503-E. Is 4648 supported with SUP V?

Hall of Fame Super Bronze

Re: 4500 Switch - Unsupported Module

You need the Sup6-E as well. See the following document:

http://www.cisco.com/en/US/prod/collateral/modules/ps2710/ps5494/product_data_sheet0900aecd802109ea.html

As I recommended, you can return this module for WS-X4548-GB-RJ45V and it should work under your current hardware.

HTH,

__

Edison.

833
Views
0
Helpful
5
Replies
CreatePlease to create content