Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4500R to HP 6600s

Hi all,

Probably something I've missed but here goes....

I have an new Blade environment that I've connected to my existing LAN. The new environment is switched through 2 (for redundancy) HP 6600 switches and each of those is trunked back to my LAN from port 24 to a 10Gb port on redundant Supervisors

I updated the firmware on one of the 6600s earlier and during the reboot cycle, I lost connectivity from Cisco side to HP side.

With the HP side being 2 separate devices, if I enable a port channel for the interfaces on the Cisco switch, will that give me the resiliency or do I need to do something else?

Thanks



Sent from Cisco Technical Support Android App

111
Views
0
Helpful
0
Replies