ich have two pairs of 4500X-32, with other word two vss-systems in a test environment. IOS running version is 03.05.02.E.152-1.E2, dual-active detection with a fast-hello link is running. When i pull the VSL connectors to simulate a failure the active switch go into recovery-mode. After the vsl is restored the switch in recovery-mode start a reboot as desired. The configuration is saved and if i repeat the procedure, all is working fine. But when i start the systems the next day and begin to test the dual-active detection again, the vsl port stucks in " waiting to be aggregated" after restoring it. No reboot happens, the only solution is to reboot the switch manually. After that this misbehavior is repeating. Only setting the dual-active detection interfaces to its default, and reconfiguring them for fast-hello dual active detection again brings the feature back to normal operation:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...