Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4506 add routing and vlan?

Also Posted at WAN switching & routing by mistake.

We have two 4506's only doing layer2 and one Vlan

Another vlan is requested.

We don't want to mess with the WAN router.

Is it just a config to add routing and Vlan, or is an upgrade necessary?

Below is a look at the system.

Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(20)EW

RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2005 by cisco Systems, Inc.

Compiled Fri 29-Jul-05 18:09 by kellythw

Image text-base: 0x00000000, data-base: 0x011F8610

ROM: 12.2(20r)EW1

Dagobah Revision 226, Swamp Revision 34

System returned to ROM by reload

System restarted at 13:29:10 CST Sat Mar 3 2007

System image file is "bootflash:"

cisco WS-C4506 (MPC8245) processor (revision 10) with 262144K bytes of memory

Processor board ID FOX092603Q7

MPC8245 CPU at 266Mhz, Supervisor II+

Last reset from Reload

1 Virtual Ethernet/IEEE 802.3  interface(s)

192 FastEthernet/IEEE 802.3 interface(s)

2 Gigabit Ethernet/IEEE 802.3 interface(s)

511K bytes of non-volatile configuration memory. 

2 REPLIES
New Member

Re: 4506 add routing and vlan?

Sure you can do both without any config on the router

Create the SVI on the L3 switch, add the vlan and dont forget to enable routing!

Hall of Fame Super Gold

Re: 4506 add routing and vlan?

Errr ... I don't think Yuk Ster can enable routing.  The Sup2+ is a layer 2 only card. 

Dot1Q and sub-interface has to be created on the router.

653
Views
0
Helpful
2
Replies
CreatePlease login to create content