Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4506 slot 6 issue

I have an older style 4506 running CAT-OS. When I add a POE blade to slot 6 it is unrecognized by the chassis.

Here is a show version from the switch.

QuadB_3 (enable) sh ver

WS-C4506 Software, Version NmpSW: 7.4(2)

Copyright (c) 1995-2002 by Cisco Systems, Inc.

NMP S/W compiled on Oct 8 2002, 18:12:59

GSP S/W compiled on Oct 08 2002, 15:54:51

System Bootstrap Version: 5.4(1)

Hardware Version: 5.1 Model: WS-C4506 Serial #: FOX34371IJ2

Mod Port Model Serial # Versions

--- ---- ------------------ -------------------- ---------------------------------

1 2 WS-X4013 JAE07091S4Y Hw : 5.1

Gsp: 7.4(2.0)

Nmp: 7.4(2)

2 48 WS-X4148-RJ45V JAB04081D6N Hw : 2.6

3 48 WS-X4148-RJ JAB04081ESM Hw : 3.1

4 48 WS-X4148-RJ JAB04081SW2 Hw : 3.1

5 48 WS-X4148-RJ JAB04220JUT Hw : 3.1

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 65536K 39986K 25550K 16384K 5520K 10864K 480K 434K 46K

Uptime is 7 days, 21 hours, 2 minutes

3 REPLIES
Purple

Re: 4506 slot 6 issue

Whats the card model # ?

New Member

Re: 4506 slot 6 issue

Thanks for the response!

WS-X4148-RJ45

Please keep in mind that this blade works in slot 2.

Thanks again!

Purple

Re: 4506 slot 6 issue

Do other cards work in slot 6 ?? also you might want to check the power , the old catos boxes had limited PS's and it may not be enough to power 2 POE blades , don't know for sure though . Does it show anything in the log for when you plug the card in ?

139
Views
0
Helpful
3
Replies