Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

4506 to Foundry F800 Trunking ?

Can anyone assist me with a config for trunking 4 gig ports in an etherchannel setup. I need to create the trunk so I can move boxes off the F800 so I can retire it.

Thanks.

1 REPLY

Re: 4506 to Foundry F800 Trunking ?

Hello Rob,

you just need to enable channel-groups on the trunk interfaces. use either pagp or lacp on the interfaces, with appropriate modes (active/passive/auto or desirable).. Are you doing etherchannel with Foundry switch ? if so, please check the configs on foundry.

With respect to cisco, u can use the following URL for configuring etherchannels:

http://cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a008011c8a9.html

Hope this helps.. let us know if you need anything else in this..

Raj

139
Views
0
Helpful
1
Replies
CreatePlease to create content