4506E with WS-X45-SUP7L-E does not see SD card or Cisco USB Driv
Sorry for the late reply.
The issue was corrected by rebooting the card which was likely the symptom of the FFM process behaving poorly. The reason the FFM process was behaving poorly was due to a misconfiguration issue relating to WCCP where the remote client was pointing to a VIP address instead of the actual interface address as well as the change in the mask to 0x1.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...