Can any one tell me if the switchport blades in the 4500 series (or 6500 series for that matter) are hot swappable? I have to add two more WS-X4248-RJ45V blades to an existing 4507 and I'm wondering if I'll need to shut that switch down (after hours) or if I can do that with the switch running (during hours). I see in the documentation where the power supplies are hot-swappable but it doesn't say anything about the blades so I am assuming no. Thanks for any infor provided.
The blade bays that are currently empty in this device is modules 2 and 7. Are both of these OK to use for adding blades or is one or all used for any other devices (i.e. the supervisor). According to the software config, module 2 and 7 are not installed.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...