We seem to be seeing an awful high failure rate on the PWR-C45-4200ACV power supplies . Its in multiple different sites . We have probably replaced a half dozen in the last 6 months and these are less than 2 years old. What we see is this . They usually look like this . We have tried reseating the power supplies etc.. and nothing seems to get them out of the err-disabled state and the message that states they are different power supplies is false as both are exactly the same . Anyone seen this problem? If we get them RMA'd and a new one installed it looks fine.
PS2 PWR-C45-4200ACV AC 4200W err-disable good good
PS2-1 220V good
PS2-2 220V good
*** Power Supplies of different type have been detected***
We have experienced the same issue with the 4200W power supplies in India as well
Even though the Power supplies were same, the switch used to throw the mixed mode power supply problems..
However we have made one observation..The power supplies that are showing these errors are all manufactured in China. When we did our RMA recently we ordered for a different one and received a Sony Power supply which seems to be stable for the past 2 weeks
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...