Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4507 span config

I have my ASA in gi7/5 and my monitoring app in gi7/6. I have the following config:

monitor session 1 source int gi7/5

monitor session 1 dest int gi7/6

When I connect the ethernet cable of the monitoring app to gi7/6 traffic to the ASA stops. Cannot get the outside. If I remove the ethernet cable from gi7/6 everything is fine.

Where have I gone wrong?

Thanks.

1 REPLY
New Member

Re: 4507 span config

I'm not sure where your problem is, but it isn't with your monitor config. Here is the conf for monitoring I'm currently doing on a 4507.

monitor session 1 source interface Gi5/20

monitor session 1 filter vlan 100

monitor session 1 destination interface Gi5/31

No problems at all. What happens when you plug a different device into gi7/6?

417
Views
0
Helpful
1
Replies