4507 is stuck in rmon. Here is the output from the bootup.
etermining FTL format status of volume. Block 506 has invalid FTL signature. Block 506 will be reformatted. Volume is FTL formatted.
Checking the partition table and boot sector... Checking FAT, Files and Directories... Reclaiming unused space... Updating FAT... Rom Monitor Program Version 12.2(44r)SG3 CPU Rev: 2.0, Board Rev: 6, Board Type: 10, CPLD Jawa Rev: 20 Chassis: WS-C4507R-E
Front Panel Phy is Bcm5482s Got Mac Address: 00:25:84:1d:c0:17
MAC Address : 00-25-84-1d-c0-17 Ip Address : Not set. Netmask : Not set. Gateway : Not set. TftpServer : Not set. rommon 1 >confreg 2102 usage: confreg rommon 2 >
The Configuration registry showed 0 and 40 at next reload. Is this the reason for the bootup in rmon?
boot bootflash: started the switch without the startup. I did a copy start run to restore service. The config-registry showed 0 and 40 at next reload. I changed it to 2102. I'll reload after hours to verify it boots up ok. Any ideas why my registry would show 0 and 40 at next reload? Other than someone manually changing it...
Here is my boot statement:
boot system bootflash:/cat4500e-ipbasek9-mz.122-53.SG1.bin
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.