Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4507 with Redundant SUPS

I get this message whenever I do a wr mem:

%HA_CONFIG_SYNC-3-IPC: cannot open standby port no such port

%C4K_REDUNDANCY-5-CONFIGSYNC: The startup-config has been successfully synchronized to the standby supervisor

%C4K_REDUNDANCY-5-CONFIGSYNC: The private-config has been successfully synchronized to the standby supervisor

%HA_CONFIG_SYNC-3-IPC: cannot open standby port no such port.

Any ideas what is going on? Redundancy Mode is set to RPR.

2 REPLIES
Blue

Re: 4507 with Redundant SUPS

The "%HA_CONFIG_SYNC-3-IPC: cannot open standby port no such port..." error is generated due to a configuration synchronization problem/error that occured.

The C4K lines are only informational stating that configuration synch did occur successfully.

Since the config sync did complete sucessfully, there should be no problem failing over to the standby if it is required. You should test this after hours to be sure.

(verify your IOS is the same version on both sups)

New Member

Re: 4507 with Redundant SUPS

Just found out the the IOS versions are different. Thats the problem.

Thanks.

434
Views
0
Helpful
2
Replies