I just replaced a 4006 with a 4507R. Prior to doing so, all ports that were not connected show auto/auto. Now with the new switch it shows half/auto. But once a system connects to that port it says full/100.
IOS is (cat4500-ipbase-mz.122-40.SG.bin)
I have never seen this before. Does anyone know what could be causing this to show these values?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...