Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4507R+E with Sup 7-E in ROMMON

Hi,

Without realizing that the ROMMON version on the platform is older (15.0(1r)SG5) then the minimum required 15.0(1r) SG7 for VSS, I converted the switch running IOS 3.4.0 SG to VSS. It took the commands and reloaded and went straight into ROMMON mode. My mistake, fortunately its not production yet and I will continue on it tomorrow. Should I upgrade ROMMON from with in ROMMON mode by downloading it via tftp or is there a way to clear VSS from within ROMMON and let the switch start in standalone mode. Tried doing "> boot <image>", still drops into ROMMON. The boot up messages suggest doing a "clear VS_SWITCH_NUMBER rommon variable to boot switch in standalone mode", but there is not command like "clear 1" for this switch.

Thanks,

Rick.

1 REPLY
Cisco Employee

4507R+E with Sup 7-E in ROMMON

Hi Rick,

I believe you need to use "unset VS_SWITCH_NUMBER" to clear the same.

Thanks & Regards,
Karthick Murugan
CCIE#39285

Thanks & Regards, Karthick Murugan CCIE#39285
238
Views
0
Helpful
1
Replies