Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4510 High CPU per blade stats

I am looking to troubleshoot high CPU on 4510. I enabled ISE(802.1x) on 4510, and CPU went up. I have a similar setup on another 4510 and CPU is normal. I think the problem is one of the older blades.. Is there a way to find out process/memory utilization per blade?

thanks

CCIE 18676
1 REPLY

4510 High CPU per blade stats

Hello Marcin.

Here is a very useful guide to troubleshoot high cpu in 4ks.

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtml

I always check for the commands:

These commands will give you a overview of what is going on.

Show process cpu sorted | ex 0.00

Show platform health

These debugs are very useful to understand what type of traffic is getting to the cpu: (Do NOT worry about the debugs they are CPU embedded and don't not cause any cpu overload)

Switch#debug platform packet all count

platform packet debugging is on

Switch#show platform cpu packet statistics

Switch#debug platform packet all receive buffer

platform packet debugging is on

Switch#show platform cpu packet buffered

You can even SPAN the cpu to determine with the help of wireshark what is getting cpu processed.

Switch(config)#monitor session 1 source cpu rx

Switch(config)#monitor session 1 destination interface gigabitethernet x/y

Regards.

Wilson B

Please rate useful post!

Regards.

Wilson B.

198
Views
0
Helpful
1
Replies