Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4510 switchmanger error message

any idea what causes this error message:

UTC: %C4K_SWITCHMANAGER-4-S2WERRORREPORT: (Suppressed 5 times)PimEthAutoNeg: S2w Read/Write Error for port

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 4510 switchmanger error message

Try reseating the modules affected. If you are not using PoE on the cards you can also disable the POE functionality by configuring "power inline never" on a the switchports. If this still doesn't help I would put in a TAC case.

If you have CCO access check out the info on the bug.

3 REPLIES

Re: 4510 switchmanger error message

Russ,

What line cards are you using? Below is the output from the error message decoder. It appears to be a bug.

%C4K_SWITCHMANAGER-4-S2WERRORREPORT: PimEthAutoNeg: S2w Read/Write Error for port [char].

A read/write error occurred on the specified port.

Recommended Action: Refer to the release notes to verify whether you can see all the symptoms described for CSCef87815. If you do not and do not see any adverse effect on the functionality of the PoE switching modules (WS-X4248-RJ45V, WS-X4248-RJ21V, WS-X4548-RJ45V, WS-X4224-RJ45V or WS-X4524-RJ45V), reseat the switching module.

HTH,

Mark

New Member

Re: 4510 switchmanger error message

48 10/100/1000BaseT (RJ45)V, Cisco/IEEE WS-X4548-GB-RJ45V

Re: 4510 switchmanger error message

Try reseating the modules affected. If you are not using PoE on the cards you can also disable the POE functionality by configuring "power inline never" on a the switchports. If this still doesn't help I would put in a TAC case.

If you have CCO access check out the info on the bug.

190
Views
0
Helpful
3
Replies