Its been a while since I've been in the IOS so please bare with me on this question. We have a 4510 that has several VLANs implemented and I need to add another VLAN to a 4510 at one location and that same VLAN to a 4507 at another location. They are connected to one another via a microwave/Ethernet link. I know how to designate a VLAN and that I need to setup a specific port on the new VLAN at either location so equipment plugged in can see one another. However, I can't recall how to tell my trunk link to use the new VLAN. For that matter I can't get the switch to show me the trunk links. A 'sh trunk' generates an 'invalid input deteted at '^'' in enable mode.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.