One of customer has 4510R series catalyst switch,we configured redundancy with 2 sup6-E engine.But problem is there are only one fibre port active on both the sup eng.
How can i configured the redandancy mode from 1:1 to 2:1 mode?
try the command 'hw-module uplink mode shared-backplane'
A 'redundancy reload shelf' or power-cycle of chassis is required to
apply the new configuration
Greetings, Stephan
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: