Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

4510R warning...

What means this?...

ep 20 07:56:33.615: %C4K_ETHPORTMAN-3-TENGIGSEEPROMREADFAILED: Failed to read seeprom on port Te5/1. If an X2 module is installed, remove and reinsert the X2. If a TwinGigConverter is installed, configure the port group for GigabitEthernet.

Im using Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(46)SG, RELEASE SOFTWARE (fc1).

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: 4510R warning...

So what does the port look like now? Can you install a total of 4 SFP's in to each sup?

4 REPLIES
Community Member

Re: 4510R warning...

Do you have 10Gb or TwinGig converter? I am going to assume twingig so you'll need to run the command:

hw-module module 5 port-group 1 select gigabitethernet

but to match your specific setup.

Community Member

Re: 4510R warning...

I don't have any converter installed.

Community Member

Re: 4510R warning...

So what does the port look like now? Can you install a total of 4 SFP's in to each sup?

Community Member

Re: 4510R warning...

i seeing a Unknow port in the show commands, see bellow:

*Sep 27 08:19:33.323: %C4K_ETHPORTMAN-3-TENGIGSEEPROMREADFAILED: Failed to read seeprom on port Te5/1. If an X2 module is installed, remove and reinsert the X2. If a TwinGigConverter is installed, configure the port group for GigabitEthernet.

*Sep 27 08:19:37.139: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan

*Sep 27 08:19:38.879: %C4K_ETHPORTMAN-3-TENGIGSEEPROMREADFAILED: Failed to read seeprom on port Te5/2. If an X2 module is installed, remove and reinsert the X2. If a TwinGigConverter is installed, configure the port group for GigabitEthernet.

Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASEK9-M), Version 12.2(46)SG, RELEASE SOFTWARE (fc1)

Phoenix#show hw-module module 5 port-group 1

Module Port-group Active Inactive

-------------------------------------------------------------

5 1 Te5/1 Gi5/3-4

Phoenix#show hw-module module 5 port-group 2

Module Port-group Active Inactive

-------------------------------------------------------------

5 2 Gi5/5-6 Te5/2

Phoenix#show int status mod 5

Port Name Status Vlan Duplex Speed Type

Te5/1 notconnect 1 full 10G Unknown X2

Te5/2 inactive 1 full 10G No X2

Gi5/3 inactive 1 full 1000 No Gbic

Gi5/4 inactive 1 full 1000 No Gbic

Gi5/5 notconnect 1 full 1000 No Gbic

Gi5/6 notconnect 1 full 1000 No Gbic

649
Views
0
Helpful
4
Replies
CreatePlease to create content