Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4900M. Configuration 1GE (RJ45) + 1GE (twingig SFP)

hi, please advice

i need to configure 4900M switch with combination WS-X4920-GB-RJ45 + WS-X4908-10GE cards and i need to use 2x10GE onboard port + 15x1GE copper ports + 6x1GE SFP optic ports (via 3 twingig converters plug into X4908-10GE card).

Do you think it would work or not?

i can't find information about it. Data sheet contains some variety configurations but does not have configuration when it is required to use 1GE (RJ45) on one card couple with 1GE (SFP) on X4908-10GE card + twingig.

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6021/ps9310/Data_Sheet_Cat_4900M.html

thanks in advance

5 REPLIES
Hall of Fame Super Silver

Re: 4900M. Configuration 1GE (RJ45) + 1GE (twingig SFP)

Hello Andrey,

configuration has to be done on groups of ports that share the same asic

Switch(config)# hw-module module m port-group p

select [gigabitethernet | tengigabitethernet]

see

http://cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/46sg/configuration/guide/sw_int.html#wp1077316')">http://cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/46sg/configuration/guide/sw_int.html#wp1077316

it explains also how to see port group mappings

Hope to help

Giuseppe

Re: 4900M. Configuration 1GE (RJ45) + 1GE (twingig SFP)

Yes, it's possible. I don't think Table 2 in data sheet gives all options.

New Member

Re: 4900M. Configuration 1GE (RJ45) + 1GE (twingig SFP)

thanks so much.

one more question:

when i order chassis 4900M with WS-X4908-10GE card, does it include 8 twingig converters (CVR-X2-SFP) or i need to reorder it for special (not zero) price?

New Member

Re: 4900M. Configuration 1GE (RJ45) + 1GE (twingig SFP)

the previous question is not actual. Thanks to everybody

Re: 4900M. Configuration 1GE (RJ45) + 1GE (twingig SFP)

Just let you know. If you want to check your hardware configuration. You can use the "Dynamic configuration tool".

https://apps.cisco.com/qtc/config/jsp/configureHome.jsp

For your above question, this tool will tell you know if "converter" is included or not.

2098
Views
0
Helpful
5
Replies