Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4948 45-48 ethernet interfaces are not up

Good day.

I have a Cisco 4948. It's 48 ethernet ports and 4 fiber ports. Moreover, fiber ports have numbers 45-48 (the same numbers ethernet ports have).

There is a link between 4948 G1/45 and 2960 G0/1.

G1/45 on 4948 is:

inter g1/45

switchport access vlan 30

switchport mode access

end

G0/1 on 2960 is the same:

inter g1/45

switchport access vlan 30

switchport mode access

end

It does not work. But if I use for example g1/43 port on 4948 with the same setting it works normally.

As I understand I should set the 45 ethernet port instead 45 fiber port as uplink. How to do this ?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: 4948 45-48 ethernet interfaces are not up

Hello Vyacheslav,

it should be something like

int gi1/45

media-type rj45

I've used it on C7200 with NPE-G1

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: 4948 45-48 ethernet interfaces are not up

Hello Vyacheslav,

it should be something like

int gi1/45

media-type rj45

I've used it on C7200 with NPE-G1

Hope to help

Giuseppe

New Member

Re: 4948 45-48 ethernet interfaces are not up

Thanks a lot.

It works.

371
Views
0
Helpful
2
Replies