Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4948 boot statements

I have 2 bootstatements in my config. is there a command to reorder those statements. I want the second statement to be the first. i want the switch to boot off the second statement.

1 REPLY
Hall of Fame Super Blue

Re: 4948 boot statements

Easiest way is to

1) 4948(config)# no

2) 4948(config)#

ie. after step 1 you will only be left with the 2nd boot statement in your running config. Then just add back in the first boot statement which should then appear as the 2nd boot statement in the running config.

Note this is fine to do while the switch is up and running, it will have no effect until switch is rebooted.

Jon

241
Views
5
Helpful
1
Replies