Went to do a password recovery on the switch so i put it in rommon. changed the register to x42 and it still booted with the password and config. After that i went back to rommon and set it to ignore startup config.. After that i booted it into a config without a password... Now no mater what i do the switch goes straight to rommon and i have to issue the boot command to get the ios to boot... Any ideas on how i can fix this?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...