Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

4948 switch log message

Dears,

   This message is appearing in my 4948 switch log

29w2d: Current Freelist count 7830. Fell below threshold 1 times consecutively
29w3d: Current Freelist count 7704. Fell below threshold 1 times consecutively
29w3d: Current Freelist count 7419. Fell below threshold 1 times consecutively
29w5d: Current Freelist count 7411. Fell below threshold 1 times consecutively
29w5d: Current Freelist count 7425. Fell below threshold 3 times consecutively
29w5d: Current Freelist count 7693. Fell below threshold 1 times consecutively
29w5d: Current Freelist count 7433. Fell below threshold 1 times consecutively
30w0d: Current Freelist count 7901. Fell below threshold 1 times consecutively

can any one tell what is this?

Regards

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: 4948 switch log message

ahmad

this is a bug related to frames size.

upgrade your ios to the latest version. this should solve the problem

it was resolved in  12.2(31)SGA

4 REPLIES
Silver

Re: 4948 switch log message

ahmad

this is a bug related to frames size.

upgrade your ios to the latest version. this should solve the problem

it was resolved in  12.2(31)SGA

Community Member

Re: 4948 switch log message

Thanks very much Mr. ohassairi

but my IOS is 12.2(31)SGA8

Community Member

Re: 4948 switch log message

any news

Community Member

Re: 4948 switch log message

Explanation 

  The PPE freelist count is being monitored. Packet buffer leak detection is on and the freelist count is being monitored. This message displays the current count and number of times the count reached the threshold. If the freelist count stays below the threshold for more than one minute, the system will be reset.This message may also erroneously appear if using jumbo packets or if sharing is configured and transmit queues have backed up.

Recommended Action    This is an informational message only. No action is required.

To suppress the automatic reset action use the diagnostic monitor action conservative command.

2224
Views
0
Helpful
4
Replies
CreatePlease to create content