Hi there, is it possible to configure a port with the Smartport role of "Phone & Desktop" on a 500 switch and have the two devices (phone & pc) connected to the same port in seperate VLANs and subnets and route between the VLANs?? I can configure this no problem using the Smartport role "desktop" and by placing two ports in seperate VLANs and subnets and can route between the VLANs using a port configured as smartport "router" plugged into a 2600 router. But i have to have each device plugged into a seperate port. Is it possible to have the phone and pc plugged into the same port on different VLANs and subnets like the auxilary VLAN config on other Catalyst switches??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...