Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

5548UP inteface state (L3 not ready)

Hi all,

 

Is anyone familiar with this interface state?  I have a layer 3 daughter card installed  in the switch and whenever I make any port layer 3 the interface goes down with a state (L3 not ready).  At this point there is no configuration on the interface and the state doesn't change once a layer 3 config is applied.  For reference the configuration is

int e1/2

no switchport

speed 1000

vrf member internet

ip address x.x.x.x/25

no shut

This configuration was working yesterday but stopped at some point and we don't know why.

 

Any assistance would be most appreciated.

 

Cheers

2 REPLIES
VIP Super Bronze

Hi,Do you have L3 license

Hi,

Do you have L3 license (LAN_BASE_LIC) installed?

HTH

New Member

Hi Reza,  I have the base

Hi Reza,  I have the base license installed and a temp LAN_ENTERPRISE_SERVICES_PKG lic which still has 112 days to go before expiry. This link was up for a week but now it's down with this error.

33
Views
5
Helpful
2
Replies