Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6000 switch MSFC in Rommon mode

Hi,

This switch is using the CATOS for layer 2 and IOS for Layer 3, So currently the CATOS is running well but the Layer 3 in the ROMMON, pls refer to below:

rommon 1 > boot sup-slot0:c6msfc-dsv-mz.121-27b.E1.bin

an alternate boot helper program is not specified

(monitor variable "BOOTLDR" is not set)

and unable to determine first file in bootflash

loadprog: error - on file open

boot: cannot load "sup-slot0:c6msfc-dsv-mz.121-27b.E1.bin"

Is it Have any idea to boot it up.

Thanks

-Gilbert

5 REPLIES
Blue

Re: 6000 switch MSFC in Rommon mode

Try the "boot slot0:c6msfc-dsv-mz.121-27b.E1.bin" command.

(dont use sup-slot0:, just slot0:)

Also, when you get the MSFC running, goto global config mode and enter the "boot system flash slot0:c6msfc-dsv-mz.121-27b.E1.bin" command to set the boot file to load automatically.

Purple

Re: 6000 switch MSFC in Rommon mode

I believe the old Supervisor 1's need to have a bootloader image loaded into msfc bootflash with the corresponding boot statement to boot up correctly . Go out and get the bootloader image that goes with this version and load it into "MSFC" bootflash and set your boot statement to reflect this , "boot bootldr bootflash: , then write mem. Also your first boot statement was correct pointing sup-slot0: .

New Member

Re: 6000 switch MSFC in Rommon mode

Hi,

I had tried the command which suggested but it come out the message as below:

rommon 2 > boot slot0:c6msfc-dsv-mz.121-27b.E1.bin

an alternate boot helper program is not specified

(monitor variable "BOOTLDR" is not set)

and unable to determine first file in bootflash

loadprog: error - on file open

boot: cannot load "slot0:c6msfc-dsv-mz.121-27b.E1.bin"

rommon 3 >

pls advise

Thanks

-Gilbert

New Member

Re: 6000 switch MSFC in Rommon mode

Hi,

Is it any 1 can help on this issue.

Much Appreciate for the help.

Thanks

-Gilbert

New Member

Re: 6000 switch MSFC in Rommon mode

Hi,

Anybody help on this issue.

Thanks a lot

-Gilbert

167
Views
0
Helpful
5
Replies
CreatePlease to create content