Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 1p3q4t Best Practice Queue Configuration

I have a 6500 Sup720 I looking for a best practice for configuration of 1p3q4t queues

GigabitEthernet5/1

Model: VS-S720-10G

Type: 1000BaseLH

Speed: 1000

Duplex: full

Trunk encap. type: 802.1Q,ISL

Trunk mode: on,off,desirable,nonegotiate

Channel: yes

Broadcast suppression: percentage(0-100)

Flowcontrol: rx-(off,on,desired),tx-(off,on,desired)

Membership: static

Fast Start: yes

QOS scheduling: rx-(2q4t),

tx-(1p3q4t)

QOS queueing mode: rx-(cos), tx-(cos)

CoS rewrite: yes

ToS rewrite: yes

Inline power: no

Inline power policing: no

SPAN: source/destination

UDLD yes

Link Debounce: yes

Link Debounce Time: yes

Ports-in-ASIC (Sub-port ASIC) : 1-5 (1-2,5)

Remote switch uplink: no

Dot1x: yes

Port-Security: yes

Thanks,

Steve

1 REPLY
Hall of Fame Super Blue

Re: 6500 1p3q4t Best Practice Queue Configuration

Steve

There is no best practice as such because it all depends on your QOS requirements within your network. Obviously the priority queue is usually used for VOIP if you are using that within your LAN.

Other than that it is entirely up to you how you classify and queue the traffic on each linecard. Be aware that QOS is handled by the PFC on the 6500 so when you apply a QOS policy to an individual port on a line card that QOS policy is applied to all ports within the same port group as the individual port.

Jon

Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.

907
Views
0
Helpful
1
Replies
CreatePlease login to create content