Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

6500 boot delay

I have a 6500 that pauses for several mintues during the boot cycle saying" Initializing ATA monitor library" I think it may be looking for boot flash that doesn't exist. The * in "show file systems" seems to be in the wrong spot (see below). Has anyone seen this before? It there somewhere I need to configure the boot devices - other than the config?

boot system flash sup-bootdisk:

File Systems:

Size(b) Free(b) Type Flags Prefixes

- - ram rw tmp:

- - opaque rw system:

- - opaque ro flexwan-fpd:

65536000 65069480 flash rw bootflash:

* - - disk rw disk0:

255938560 187367424 disk rw sup-bootdisk:

52287596 0 opaque ro sup-microcode:

0 551411360 opaque wo sup-image:

126956 125780 nvram rw const_nvram:

1961976 1939775 nvram rw nvram:

- - opaque rw null:

- - opaque ro tar:

- - network rw rcp:

- - network rw scp:

- - network rw tftp:

- - network rw ftp:

- - opaque ro cns:

Thanks

-Julianne

124
Views
0
Helpful
0
Replies
CreatePlease to create content