Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6500 Bootvar

The bootvar are not the same for the VSS 6500s. Specifically the CONFIG_FILE and BOOTLDR indicate "variable does not exist" on the active unit but show "=" on the standby. This VSS system is working ok but trying to figure out the differences and how to correct them.

(Is this an SP or ROMMON setting?) These are new units.

Regards

Joe

vss#sho boot

BOOT variable = sup-bootdisk:s72033-ipservicesk9_wan-mz.122-33.SXI.bin,1;

CONFIG_FILE variable does not exist

BOOTLDR variable does not exist

Configuration register is 0x2102

Standby is up

Standby has 1048576K/65536K bytes of memory.

Standby BOOT variable = sup-bootdisk:s72033-ipservicesk9_wan-mz.122-33.SXI.bin,1;

Standby CONFIG_FILE variable =

Standby BOOTLDR variable =

Standby Configuration register is 0x2102

2 REPLIES
Silver

Re: 6500 Bootvar

No this is not an issue. This statement means that the CONFIG_FILE variable is not set manually and will store the configurations on the NVRAM.

New Member

Re: 6500 Bootvar

Thanks. I was just trying to get both sups to show the same thing. (Customer has another VSS where both switches show the same thing.)

Thank you again.

Joe

434
Views
0
Helpful
2
Replies