Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

6500-E SUP2T compatibility

I have two 6500-E chassis with SUP2T on them.

one of the chassis is having the latest WS-X6848-SFP while the other one is having WS-X6748-SFP.

both the line cards are having the same WS-F6K-DFC4-A.

 

if i will configure VSS between these chassis, will there be any issues ?

 

 

Everyone's tags (1)
2 REPLIES
Super Bronze

DisclaimerThe Author of this

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Shouldn't be.

Silver

Hi,  You should not have any

Hi,

 

 

You should not have any issues with the VSS set up, both type of line cards are compatible with the Sup-2T. See the link below for any details about the modules:

http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/catalyst-6500-series-supervisor-engine-2t/qa_c67-648478.html

 

Hope this helps.

71
Views
0
Helpful
2
Replies
CreatePlease to create content