Error Message EOBC-2-EOBC_JAM: EOBC channel is jammed. Attempting
to diagnose the source of the problem and recover if possible.
Explanation This message indicates that the SP is unable to communicate with other processors in the system because of a problem with the EOBC channel. The problem could be due to faulty EOBC hardware on the supervisor engine or due to a module with a faulty connector to the EOBC channel. The SP will attempt to recover automatically. The success of this automatic recovery will be communicated through more messages.
Recommended Action No action is required.
Error Message EOBC-2-EOBC_JAM_RECOVERED: [chars] in slot [dec] is
jamming the EOBC channel. It has been disabled. [chars]
Explanation This message indicates that the specified module has faulty hardware and is adversely affecting the operation of the switch. The remaining modules will be power cycled and brought online.
Recommended Action Immediately replace the module in the slot specified in the error message
I had the same message and replaced the module in the reported slot and the problem was fixed.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...