does anybody know or has a document with examples of how to configure 6500 with inter-vlan bridging ?, i need to understand that if i have multiple vlan on my 6500 and i need that all the vlans will be able to forward L2 frames between them, should i configure under each vlan interface a different bridge-group or the same bridge-group? (if it is the same bride-group, doesn't it a loop?)
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...