Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 MLS and drop packet

hey folks

any one can help to how to check routing module (MSFC) in 6513 switch is working fine or not. Specifically any idea about checking packet drops on MSFC interface

Thanks

1 REPLY
Hall of Fame Super Silver

Re: 6500 MLS and drop packet

Hello Subharoj,

if multi layer switching is working MSFC should process very few traffic.

So first of all verify your mls settings.

I suppose you are using Hybrid mode catOS on supervisor and IOS on MSFC.

show mls

it says if it is enabled

there is a line that tells who is the RP verify that the ip address is one of the MSFC.

you can telnet to the MSFC with session N

where N can be found on the output of sh module on the supervisor. (15 on cat6509)

MSFC to supervisor should use a 4Gpbs pipe via catalyst bus.

Hope to help

Giuseppe

117
Views
0
Helpful
1
Replies
CreatePlease login to create content