I'm having a problem doing NAT translations between Vlans. I have a nat inside vlan with a private segment and a nat outside vlan with a public ip address. The problem I'm having is that at times the CPU of the switch peaks to 100%. I think it's a limitation of the 6500 when it gets to the max nat entries. The process IP NAT ager is the one I have with the most utilization with 80-90%. Here is a show ip nat statistics. The question is what is the max nat entries for the 6500 so I can configure it as the max-entries?
Router#sh ip nat statistics
Total active translations: 10763 (0 static, 10763 dynamic; 10763 extended)
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...