I have an IP subnet of 172.16.0.0/16 on vlan 1 and just configured a vlan 145 interface and bound 172.16.145.0/24 to it. When I did that I get a message that vlan 145 IP overlaps with vlan 1. No problems yet, but I haven?t ?no shut? int vlan 145. I have no 172.16.145.x hosts on vlan 1
How does a 6500 handle this scenario? Is there any bugs or weirdness? Anything else I should be aware of that will happen when int vlan 145 is brought up?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.