Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ovt Bronze
Bronze

6500: "Unable to change flowmask" error message

I'm getting the following error messages when trying to change flowmask:

xxx(config)#mls flow ip interface-full

Unable to change flowmask to interface and full flow because Cw is configured

xxx(config)#mls flow ip full

Unable to change flowmask to full-flow because Cw is configured

xxx(config)#mls flow ip destination-source

Unable to change flowmask to destination and source address because Cw is configured

The question is: What is "Cw"? This is a Sup2 6506 with IOS 12.2(18)SXF5, two Sups, SSO/NSF, GLBP, MST, PAgP, LACP, PVLANs, OSPF, VACLs, RACLs configured. Nothing else.

2 REPLIES
New Member

Re: 6500: "Unable to change flowmask" error message

You will not be able to change the flowmask after you configure NAT.

You might be hitting the bug CSCsb41562.

ovt Bronze
Bronze

Re: 6500: "Unable to change flowmask" error message

This is Sup2 system which doesn't support hardware NAT.

140
Views
0
Helpful
2
Replies
CreatePlease login to create content