Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 traffic shaping

Hi,

I am trying to shape traffic on a gigabit interface (hardware is an LC single mode module) on a 6500 to 280Mbps. The interface mode shaping command lets me shape only upto 100mbps. policy-maps allow me to shape at more than 100mbps , however, when I apply the policy-map to the interface I get this error. Anybody know how to get around this and why this interface doesnt support outbound queuing.

"shape peak command is not supported in output direction for this interface

Configuration failed!"

3 REPLIES

Re: 6500 traffic shaping

What is the exact module where you are trying to configure this on? In could be a feature limitation for the specific module

Narayan

Silver

Re: 6500 traffic shaping

Aditionally to what Narayan pointed out: most boxes have features that are related to a box as a whole.

E.G. 2940 with 4P/4Q, 2950 with 1P3Q/4Q all WRR, then 3560 and 3750 with SRR and input queues, 4506 too have box features.

But 6500 has features on linecards itself. Therefore each linecard have different capabilities.

Check features for your exact linecard. What line card is that?

New Member

Re: 6500 traffic shaping

I think it is

GLC-LH-SM

1000base lx

591
Views
0
Helpful
3
Replies