I set vrf-lite runing eigrp on my 6500 and tried to build the neighbor with other external eigrp, but fails? If I use ospf replaced eigrp and it works. Only eigrp not work. The debug on vrf 6500 shows "18.104.22.168 not routable" when I runing eigrp. But when I running ospf the multicast "22.214.171.124"
Does vrf-lite not support eigrp ? or i missed some command???
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...