Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 VSS and VPN (IPSEC-3) port adapter

From what I have found the VPN (WS-IPSEC-3) port adapter (on a WS-SSC-600) is not supported if you decide to turn the 6509-E into a VSS system.  Is this correct?  Thanks!

3 REPLIES
Cisco Employee

Re: 6500 VSS and VPN (IPSEC-3) port adapter

It is not supported as of now. You might want to contact your Cisco sales team about future roadmap.

Regards,

jerry

New Member

Re: 6500 VSS and VPN (IPSEC-3) port adapter

Hello,

Need the same information for a VSS design (for IPSEC-2G card), but still could not find information about whether it is/will be supported or not. Could you get any information from Cisco sales team about the roadmap?

Best Regards,

New Member

Here is what we have recently

Here is what we have recently been able to achieve:

We have two sets of VSS 6509s with WAN interconnectivity between them over a microwave radio.

We have one SSC-600 and one IPSEC-3 module in each of the four (4) chassis.

We are encrypting all traffic that traverses the WAN connection.

Our problem: We can only specify the use of one IPSEC module or the other in each of the VSSs. If the chassis that has the in-use IPSEC module goes down, we will lose all connectivity.

Does anyone know the path I should take to enable the redundancy of the IPSEC modules?

Thanks!

Cliff

324
Views
0
Helpful
3
Replies
CreatePlease login to create content