6500 VTP VLANS Disappear while in transparent mode
I just ran across an issue I have never seen before. We have a switch configured with about 250 VLANs and SVIs. The switch is configured in VTP transparent mode. Everything has been working fine until this morning we added a couple more vlans. After that we noticed that all but about 80 of the VLANs in the VTP database were missing. Somehow they got erased. No one was in the device since this happened and its configured in trans mode. Any ideas what could have happened? We put the VLANs back in and everything came up fine for now.
Anyone ever heard of something like this happening? Is there a max number of L3 interfaces for 6500?
Re: 6500 VTP VLANS Disappear while in transparent mode
Someone else on puck ran into the same problem on SXH - twice. I have not seen it rear its head again and TAC can't repeat it yet so we might not get anywhere with this. I will post if something else comes up.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...