Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

6506 config for VSS using 10G LRM module and 1G Ethernet port

Hi Team,

We have Two 6506-E VSS bundle switches with 2Nos. of 10G LRM modules.

We are trying to implement for VSS between two switches using 10G LRM and 1G Ethenrenet port of each switches. I would like to know that this scenario  will work or not!! If yes pls guide us for the same.

It's URGENT....I am on site...waiting for reply...

1 REPLY
Hall of Fame Super Blue

Re: 6506 config for VSS using 10G LRM module and 1G Ethernet por

sdevesh wrote:

Hi Team,

We have Two 6506-E VSS bundle switches with 2Nos. of 10G LRM modules.

We are trying to implement for VSS between two switches using 10G LRM and 1G Ethenrenet port of each switches. I would like to know that this scenario  will work or not!! If yes pls guide us for the same.

It's URGENT....I am on site...waiting for reply...

If you mean you want to use the 1Gbps port as part of the VSL link between the 2 switches then no you can't. The VSL is made up of 10Gbps connections of which you can have up to 8.

If you mean an etherchannel connection, again no you cannot mix ports of different speeds in the same etherchannel.

Jon

623
Views
0
Helpful
1
Replies
CreatePlease to create content